Interior Wall Removal in Toronto & the GTA
Partition and load-bearing wall removal, including permits, temporary support and beam installation.
- We reply within 24 hours
- We work in 11 cities
Get an estimate for your interior wall removal
Takes about 2 minutes
Free in-person consultation and estimate
We come to the property in person, look at the work and give you an estimate at no cost and no obligation.
Step 1 of 7 · Question 1 of 1
A real person responds within 24 hours.
What’s included
This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.
Finding out what the wall carries
Before anything else we open up enough to see the joists above and what is bearing on the wall.
Non-load-bearing wall removal
Partition and stud walls taken out, with the drywall, studs and plates removed cleanly.
Drywall, stud and debris removal
Board, framing, insulation and fixings taken out and hauled away, not left in the driveway.
Services found before they are cut
Wiring, plumbing, ducts and vents inside the wall are traced and rerouted by the trade partner for each.
Stamped structural drawings
Where the wall is load-bearing, the beam and its supports are designed and stamped by an independent professional engineer.
Building permit
Removing a load-bearing wall is a structural alteration, so we apply for the municipal building permit and manage the review.
Temporary support before anything moves
Floor and ceiling loads are carried on temporary walls or posts before the bearing wall is touched.
Beam and post installation
The beam set, posts and their footings built, and the load transferred to it under the stamped design.
Making good
Ceiling, floor and walls patched back, the beam boxed in or left exposed as you choose, ready for paint.
Inspections through to final
We book and attend each inspection the permit requires and hold the file to final approval.
How it runs
Every job we take on follows the same sequence, from the first call to the walkthrough.
Tell us about the wall
Where it is, roughly how long it is, and what sits directly above it.
We call you back
Within 24 hours, with the questions that decide whether the wall is carrying anything.
Site visit and load assessment
We look at the joist direction, the floor above and the basement below before anyone gives you a number.
Written estimate once the wall is understood
You get a price for what the wall actually needs, rather than a guess that changes the day it opens up.
Drawings, engineering and permit
Where the wall is load-bearing, an independent qualified professional prepares and stamps the structural design, and we file the permit.
Protection, shoring and removal
Dust protection up, temporary support in, then the wall and its framing taken out.
Beam, making good and final inspection
Beam and posts installed, surfaces patched back, and the final inspection passed where a permit applies.
That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.
Get a free estimateAny permits a project requires are arranged for that project and shown to you before work starts.
Related services
- Masonry & BrickworkBrick, block, stone, chimneys and tuckpointing.
- Concrete WorkFoundations, slabs, walkways and structural concrete.
- Foundation RepairCrack repair, structural reinforcement and settlement correction.
- Basement Underpinning & LoweringIncrease basement ceiling height with engineered underpinning or bench footing.
Where we work
Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.
Tell us about your project
Two minutes. A real person calls you back within 24 hours.