Skip to main content
Behfar Building

Welding & Metal Fabrication in Toronto & the GTA

Structural steel, railings, gates and custom fabrication.

A person wearing a welding helmet grinding a metal beam with sparks flying

Photo by Josh Beech on Unsplash

Get an estimate for your welding & metal fabrication

Takes about 2 minutes

Free in-person consultation and estimate

We come to the property in person, look at the work and give you an estimate at no cost and no obligation.

Step 1 of 7 · Question 1 of 1

What do you need made? (required)

A real person responds within 24 hours.

What’s included

This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.

  • Site measurement

    Dimensions taken from the building rather than from an assumption.

  • Shop drawings

    What will be fabricated drawn and approved before steel is cut.

  • Structural steel

    Beams, columns, lintels and posts fabricated and installed to an engineered design.

  • Railings and guards

    Interior and exterior railings built to the heights and opening limits the Code requires.

  • Gates and fencing

    Custom gates, frames and hardware, hung so they still close in five years.

  • Stair stringers and platforms

    Steel stairs and landings fabricated and set.

  • On-site welding and repair

    Repairs and modifications carried out in place where removal is not practical.

  • Finishing

    Ground, primed and painted, galvanized or powder coated as the location requires.

How it runs

Every job we take on follows the same sequence, from the first call to the walkthrough.

  1. Tell us what you need made

    What it is, where it goes, and whether it carries load.

  2. We call you back

    Within 24 hours, to arrange measurement and understand the detail.

  3. Site visit and written estimate

    We measure, discuss the finish, and quote fabrication and installation in writing.

  4. Drawings and engineering

    Shop drawings prepared, with structural design by a qualified professional where required.

  5. Fabrication

    Cut, welded and finished in the shop to the approved drawings.

  6. Installation

    Delivered, set, fixed and, where needed, welded in place.

  7. Finishing and walkthrough

    Welds dressed and coated, then the work checked and walked with you.

That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.

Get a free estimate

Any permits a project requires are arranged for that project and shown to you before work starts.

Where we work

Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.

Tell us about your project

Two minutes. A real person calls you back within 24 hours.

Call 647-394-5886