Skip to main content
Behfar Building

Heating & HVAC in Toronto & the GTA

Furnaces, ductwork, boilers and air conditioning.

A air conditioner sitting on the side of a building

Photo by alpha innotec on Unsplash

Get an estimate for your heating & hvac

Takes about 2 minutes

Free in-person consultation and estimate

We come to the property in person, look at the work and give you an estimate at no cost and no obligation.

Step 1 of 7 · Question 1 of 1

What do you need? (required)

A real person responds within 24 hours.

What’s included

This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.

  • Trade partners

    Gas work is performed by our gas partners; electrical by an electrician.

  • Heat loss assessment

    Equipment sized to the house rather than matched to whatever is being replaced.

  • Furnace and boiler installation

    Units installed, vented and commissioned to the manufacturer's instructions.

  • Air conditioning

    Condenser, coil and line set installed, evacuated and charged properly.

  • Ductwork

    New and modified duct runs sized, sealed and insulated where required.

  • Venting and combustion air

    Flue and combustion air arranged to the Code and the appliance's requirements.

  • Condensate handling

    Drains and pumps installed so condensate goes somewhere it belongs.

  • Thermostats and zoning

    Controls installed, configured and explained.

  • Commissioning and paperwork

    System started, measured and documented, and the paperwork left with you.

How it runs

Every job we take on follows the same sequence, from the first call to the walkthrough.

  1. Tell us about the system

    What you have, its age, the size of the house, and what is not working.

  2. We call you back

    Within 24 hours, to understand the house and the existing equipment.

  3. Site visit and written estimate

    We assess the house, ducts and venting, and quote the scope in writing.

  4. Equipment selection and permits

    Equipment sized and chosen, with permits and gas approvals arranged.

  5. Removal and installation

    Old equipment removed and the new unit set, ducted and vented.

  6. Inspection and commissioning

    Gas inspection completed, then the system started, measured and balanced.

  7. Handover

    Controls demonstrated, filters explained, and the documentation handed over.

That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.

Get a free estimate

Any permits a project requires are arranged for that project and shown to you before work starts.

Where we work

Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.

Tell us about your project

Two minutes. A real person calls you back within 24 hours.

Call 647-394-5886