Skip to main content
Behfar Building

Locksmith & Security Hardware in Toronto & the GTA

Locks, smart locks, rekeying and door hardware.

Close-up of an old door handle and lock with key

Photo by Azmar Aso on Unsplash

Get an estimate for your locksmith & security hardware

Takes about 2 minutes

Free in-person consultation and estimate

We come to the property in person, look at the work and give you an estimate at no cost and no obligation.

Step 1 of 7 · Question 1 of 1

What do you need? (required)

A real person responds within 24 hours.

What’s included

This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.

  • Door and frame assessment

    We check whether the door, frame and strike are the real weakness before selling a lock.

  • Lock supply and installation

    Deadbolts, handlesets and mortise locks fitted and aligned to the strike.

  • Smart lock installation

    Keypad and connected locks fitted, set up and tested on your network.

  • Rekeying

    Existing cylinders rekeyed so old keys stop working without replacing the hardware.

  • Keyed-alike sets

    Multiple doors set to one key where you want to carry fewer.

  • Strike and frame reinforcement

    Longer screws, reinforced strikes and repaired jambs, which is what actually resists a kick.

  • Patio and secondary door security

    Sliding door locks, pins and auxiliary hardware fitted.

  • Commercial hardware

    Closers, panic hardware and access control fitted to the requirements of the space.

How it runs

Every job we take on follows the same sequence, from the first call to the walkthrough.

  1. Tell us what you need

    New locks, rekeying, smart locks, or a door that no longer closes properly.

  2. We call you back

    Within 24 hours, to confirm the doors and hardware involved.

  3. Site visit and written estimate

    We look at the doors and frames, and quote the scope in writing.

  4. Hardware selection

    Locks, finish and keying arrangement chosen.

  5. Preparation

    Doors and frames repaired or reinforced where the hardware needs solid backing.

  6. Installation and keying

    Hardware fitted, aligned, keyed and, for smart locks, configured.

  7. Testing and handover

    Every lock tested with you, keys and codes handed over and recorded.

That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.

Get a free estimate

Any permits a project requires are arranged for that project and shown to you before work starts.

Where we work

Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.

Tell us about your project

Two minutes. A real person calls you back within 24 hours.

Call 647-394-5886