Skip to main content
Behfar Building

Mold Remediation in Toronto & the GTA

Mold testing, containment and safe removal.

A white wall with black moldy paint on it

Photo by Hydra 4x on Unsplash

Get an estimate for your mold remediation

Takes about 2 minutes

Free in-person consultation and estimate

We come to the property in person, look at the work and give you an estimate at no cost and no obligation.

Step 1 of 7 · Question 1 of 1

What are you dealing with? (required)

A real person responds within 24 hours.

What’s included

This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.

  • Find the moisture first

    Mould is a symptom; we locate and fix the water source or it comes back.

  • Assessment and testing

    Visual inspection and, where appropriate, sampling by an independent party.

  • Containment

    The work area sealed off so spores are not distributed through the house.

  • Negative air and filtration

    HEPA filtration and negative pressure maintained while the work is open.

  • Removal of affected material

    Porous material that cannot be cleaned is cut out and bagged rather than treated.

  • Cleaning and HEPA vacuuming

    Remaining surfaces cleaned and vacuumed with HEPA equipment.

  • Drying

    The area dried to a measured target before anything is closed up.

  • Rebuild

    Framing, insulation, drywall and finishes restored once the area is clear and dry.

  • Post-remediation verification

    Independent clearance arranged where the situation calls for it.

How it runs

Every job we take on follows the same sequence, from the first call to the walkthrough.

  1. Tell us what you have found

    Where it is, how big an area, and whether there has been a leak or flood.

  2. We call you back

    Within 24 hours, to understand the extent and the moisture source.

  3. Inspection and written estimate

    We inspect, measure moisture and set out the scope in writing.

  4. Containment set-up

    The area sealed, filtration installed and negative pressure established.

  5. Removal and cleaning

    Affected material removed and bagged, and surfaces cleaned and HEPA vacuumed.

  6. Drying and verification

    The area dried to target and, where appropriate, independently verified.

  7. Rebuild and walkthrough

    Finishes restored, the moisture source fixed, and the work walked with you.

That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.

Get a free estimate

Any permits a project requires are arranged for that project and shown to you before work starts.

Where we work

Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.

Tell us about your project

Two minutes. A real person calls you back within 24 hours.

Call 647-394-5886