Skip to main content
Behfar Building

EV Charger Installation in Toronto & the GTA

Level 2 home EV charger installation and panel assessment.

Electric vehicle charger plugged into car

Photo by CHUTTERSNAP on Unsplash

Get an estimate for your ev charger installation

Takes about 2 minutes

Free in-person consultation and estimate

We come to the property in person, look at the work and give you an estimate at no cost and no obligation.

Step 1 of 7 · Question 1 of 1

What do you need? (required)

A real person responds within 24 hours.

What’s included

This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.

  • Electrical partner

    Installation is performed by our electrical partner and notified to the ESA.

  • Panel and load assessment

    We check whether your existing service can carry the charger before quoting one.

  • Dedicated circuit

    A properly sized breaker and circuit run to the charger location.

  • Load management options

    Where the service is tight, a load management device instead of a service upgrade.

  • Charger mounting

    Unit mounted at a sensible height and position for how you actually park.

  • Cable routing

    Runs through garage, basement or exterior wall, protected and neatly fixed.

  • Outdoor and detached installs

    Weather-rated equipment and, where needed, a feed to a detached garage.

  • ESA inspection and certificate

    The installation is inspected and the certificate given to you, which rebate programs ask for.

  • Commissioning

    Charger connected to your network, tested with the vehicle and demonstrated.

How it runs

Every job we take on follows the same sequence, from the first call to the walkthrough.

  1. Tell us about your setup

    Vehicle, where you park, and where the panel is.

  2. We call you back

    Within 24 hours, to ask about the panel size and the run length.

  3. Site visit and written estimate

    An electrician checks the service and the route, and we quote in writing.

  4. Charger selection and ESA notification

    Unit chosen and the work notified to the Electrical Safety Authority.

  5. Circuit installation

    Breaker, cable and mounting installed and the charger fitted.

  6. Inspection

    ESA inspection completed and the certificate issued.

  7. Commissioning and handover

    Charger tested with your car, the app set up, and the certificate handed to you.

That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.

Get a free estimate

Any permits a project requires are arranged for that project and shown to you before work starts.

Where we work

Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.

Tell us about your project

Two minutes. A real person calls you back within 24 hours.

Call 647-394-5886