Standby Generators in Toronto & the GTA
Whole-home backup generator supply and installation.
Photo by Troy Bridges on Unsplash
- We reply within 24 hours
- We work in 11 cities
Get an estimate for your standby generators
Takes about 2 minutes
Free in-person consultation and estimate
We come to the property in person, look at the work and give you an estimate at no cost and no obligation.
Step 1 of 7 · Question 1 of 1
A real person responds within 24 hours.
What’s included
This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.
Trade partners
Electrical work by our electrical partner; gas connection by our gas partner.
Sizing assessment
We work out what you actually want to run, rather than selling the biggest unit.
Siting and clearances
Location chosen for manufacturer clearances, exhaust direction, noise and the bylaw.
Pad and mounting
A level concrete or composite pad prepared and the unit anchored.
Transfer switch
Automatic or manual transfer switch installed so the generator can never backfeed the grid.
Fuel connection
Natural gas or propane supply sized and connected by our gas partner.
Electrical connection and ESA
Feeders and the transfer switch wired, notified and inspected by the ESA.
Commissioning and load test
The unit started, load tested and the automatic exercise schedule set.
Owner demonstration
We show you how it starts, what to check, and what the service intervals are.
How it runs
Every job we take on follows the same sequence, from the first call to the walkthrough.
Tell us what you want backed up
The whole house or specific circuits, and what fuel is available.
We call you back
Within 24 hours, to ask about your service, fuel and siting.
Site visit and written estimate
We assess the panel, the gas supply and the location, and quote in writing.
Permits and notifications
Gas and electrical approvals arranged, and the ESA notified.
Pad, fuel and electrical rough-in
Pad placed, fuel line run and the transfer switch and feeders installed.
Inspection and connection
Gas and ESA inspections completed, then the unit connected.
Commissioning and walkthrough
Load tested, exercise schedule set, and operation demonstrated to you.
That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.
Get a free estimateAny permits a project requires are arranged for that project and shown to you before work starts.
Related services
Where we work
Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.
Tell us about your project
Two minutes. A real person calls you back within 24 hours.