Skip to main content
Behfar Building

Network & Low-Voltage Cabling in Toronto & the GTA

Structured cabling, Wi-Fi, security and AV wiring.

Fiber optic cables connected to a network switch in a server rack

Photo by Kirill Sh on Unsplash

Get an estimate for your network & low-voltage cabling

Takes about 2 minutes

Free in-person consultation and estimate

We come to the property in person, look at the work and give you an estimate at no cost and no obligation.

Step 1 of 7 · Question 1 of 1

What do you need? (required)

A real person responds within 24 hours.

What’s included

This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.

  • Coverage and capacity survey

    We check where the dead spots are and what the building is made of before planning runs.

  • Structured cabling

    Category cable run from a central location to each outlet, tested and labelled.

  • Patch panel and rack

    A terminated patch panel and tidy enclosure instead of a knot of cable in a closet.

  • Wi-Fi access points

    Ceiling and wall access points placed for coverage and wired back to the rack.

  • Outlets and faceplates

    Wall plates installed and labelled to match the panel.

  • Coax, AV and speaker wiring

    Media and speaker cable run alongside the data infrastructure.

  • Camera and security cabling

    Runs to camera and sensor locations, with power over Ethernet where used.

  • Certification testing

    Every run tested and the results handed over.

  • Documentation

    A labelled schedule of every outlet, so the next person is not guessing.

How it runs

Every job we take on follows the same sequence, from the first call to the walkthrough.

  1. Tell us about the building

    Size, number of outlets you want, and what the current Wi-Fi is like.

  2. We call you back

    Within 24 hours, to understand the layout and the rack location.

  3. Site visit and written estimate

    We walk the building, plan routes and quote in writing.

  4. Design and outlet locations

    Outlet positions, access point locations and the rack position agreed.

  5. Cable pulling

    Runs pulled, ideally while walls are open, and supported properly.

  6. Termination and testing

    Panel and outlets terminated, then every run tested and labelled.

  7. Equipment setup and handover

    Switch and access points configured, coverage checked, and the documentation handed over.

That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.

Get a free estimate

Any permits a project requires are arranged for that project and shown to you before work starts.

Where we work

Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.

Tell us about your project

Two minutes. A real person calls you back within 24 hours.

Call 647-394-5886