Skip to main content
Behfar Building

Ventilation & Air Quality in Toronto & the GTA

HRV/ERV systems, exhaust and whole-home ventilation.

A roof ventilator on top of a building under construction

Photo by Guille B on Unsplash

Get an estimate for your ventilation & air quality

Takes about 2 minutes

Free in-person consultation and estimate

We come to the property in person, look at the work and give you an estimate at no cost and no obligation.

Step 1 of 7 · Question 1 of 1

What do you need? (required)

A real person responds within 24 hours.

What’s included

This is the work itself, item by item. If your job does not need one of these, it is not on your estimate.

  • Airflow assessment

    We look at what the house actually has for fresh air and exhaust before adding equipment.

  • HRV and ERV installation

    Units sized for the house, mounted, ducted and balanced.

  • Duct design and installation

    Supply and exhaust runs sized and routed so the system can reach its rated flow.

  • Bathroom and kitchen exhaust

    Fans and range hoods vented to the outside, never into an attic or soffit.

  • Dryer venting

    Runs shortened, straightened and terminated properly.

  • Makeup air

    Provided where a large hood or an exhaust appliance would otherwise depressurise the house.

  • Controls

    Timers, humidity sensors and wall controls fitted and explained.

  • Balancing and testing

    Airflows measured and balanced, with the results written down.

  • Filter access

    Equipment located so you can actually reach the filters to change them.

How it runs

Every job we take on follows the same sequence, from the first call to the walkthrough.

  1. Tell us about the problem

    Condensation, stale air, bathroom moisture, or a new build requirement.

  2. We call you back

    Within 24 hours, to understand the house and the existing system.

  3. Site visit and written estimate

    We assess the house and the duct routes, and quote the scope in writing.

  4. Equipment selection

    Unit and controls chosen and sized for the house.

  5. Duct installation

    Runs installed, sealed and insulated where they pass through unconditioned space.

  6. Equipment installation and connection

    Unit mounted and connected, with electrical work by an electrician.

  7. Balancing and handover

    Airflows measured and balanced, and the controls demonstrated to you.

That is the whole job. Tell us about yours and we will price it — a real person calls you back within 24 hours.

Get a free estimate

Any permits a project requires are arranged for that project and shown to you before work starts.

Where we work

Based in Newmarket. Working across Toronto, York Region, Simcoe and Durham.

Tell us about your project

Two minutes. A real person calls you back within 24 hours.

Call 647-394-5886